Neplan 543
DOWNLOAD > https://urlca.com/2sBMY1
Adding Instances for Regulators and components because yousaved this User defined Model (UVM) in a standard NEPLAN. Youshould define the NEPLAN component now, then somewhere in your net(wires, panels, relays, etc) you have to add this component and thereplace it in the NEPLAN network with the NET identifier whichyou have assigned for the component. The NEPLAN model is notexecuted. The NEPLAN chart manager displays all components as asource or target value. You still have to set value (see------------------------------------------------------------ below) of the component.
Before you can start the simulation NEPLAN checks whetherthe NEPLAN component exists or not. For each NEPLAN component youmust assign a value to the Power Factor, Load Factor,Saturation Power and Thermal rating. For this you have to click onthe NEPLAN component, then you have to define the values withthe following menus: 1. Exciter models: if you select a NEPLANregulator model (e.g. NEPLAN exciter model) the parameter list(button ) will be expanded with the parameters of the listedregulator model. Select the parameter in the parameter list for eachparameter, then you have to define the value (menu ).
Note that the NEPLAN model is not executed. After the dynamicsimulator has been run, the results of these calculations arestored in the NEPLAN chart manager. You can define the name of thefile where these results should be written. The file is createdattached to a directory, which is created as user defined model. 7211a4ac4a